Replacing Batteries In The Transmitter - Åkerströms SESAM 800 Bedienungsanleitung

OPERATING MANUAL

11 REPLACING BATTERIES IN THE TRANSMITTER

If the indication LED on the transmitter indicates low battery, replace the batteries promptly.
Before changing the batteries note that changing of batteries must take place in a clean environ-
EN
ment free from static electricity.
The batteries are changed as follows:
1. Open the battery cover by unscrewing the 6 screws on the backside of the
transmitter housing (see fig. 6).
2. Carefully remove the cover by lifting up the front of the cover (see fig. 8).
3. Remove the used batteries and insert new batteries (see fig. 7).
4. Close the cover by first inserting the rear of the cover into the transmitter,
and the pushing the top back down.
5. Tighten the 6 screws (torque 1.0 Nm).
Figure 6.
Figure 7.
Batteries inserted in the
transmitter. Make sure
the batteries are inserted
with the correct polarity
Document-ID: 947422-000 Multi
Battery cover and
the screws holding
the cover
Figure 8.
12 (112)
Rear side of the cover
inserted in its position
Version: C0