Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL TE-BJ 18 Li Originalbetriebsanleitung

6.3 Positioning the biscuit jointer and cutting
slots (Fig. 14)
Cutting slots with an angle of 0° at a particu-
lar height
•
Adjust the angle stop (11) to 0° and then in-
sert the height-adjustable stop (14).
•
Adjust the required height with the aid of the
height-adjustable stop (14) (see 5.5).
•
Position the machine close to the workpiece.
•
There are markings (a) on the machine; the-
se must line up with the line marked on the
workpiece.
•
Then switch on the machine and push the
handle (12) forward. The workpiece must be
securely clamped when doing this.
Cutting slots with an angle between 0° and
90°
•
Adjust the required cutting depth and check
it (see 5.2).
•
Adjust the required cutting angle using the
angle stop (11) (see 5.3).
•
Position the machine close to the workpiece.
•
There are markings (a) on the machine; the-
se must line up with the line marked on the
workpiece.
•
Then switch on the machine and push the
handle (12) forward. The workpiece must be
securely clamped when doing this.
CAUTION! The height-adjustable stop (14) must
only be used with a cutting angle of 0°.
6.4 Connecting the workpieces (Figs. 15-16)
•
Once you have cut a slot on both workpieces
they can be connected.
•
Apply glue in both slots.
•
Insert the biscuit (a) into one of the slots (Fig.
15).
•
Slide both workpieces together (Fig. 16).
•
Clamp the workpieces and wait until the glue
has set.
7. Cleaning, maintenance and
ordering of spare parts
Hazard!
Always pull out the battery pack before starting
any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
Anl_TE_BJ_18_Li_SPK13.indb 20
GB
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
- 20 -
10.11.2021 08:20:29