A&D GX-M-Serie Schnellstartanleitung Seite 8

EN
Key operation
Key operations affect how the balance functions. Normal key
operation during measurement is "Press and release the key
immediately" or "Press the key". Please do not "Press and hold
the key (for 2 seconds)" unless required.
Key
Turns the display
turned off. The weighing mode is enabled when the display is turned on.
When password function is enabled, password input display will be displayed. Refer
to the separate instruction manual "21-2 How to Input The Password At The Start Of
Weighing"
This ON:OFF key is available anytime. Pressing the
operation will interrupt operation and turn the display OFF. *
In the weighing mode, turns the digit for
readability on and off.
In the counting or percent mode, enters the
sample storing mode.
Switches the weighing units stored in the
function table.
Performs calibration of the balance using
the internal mass. (GX-M series)
Stores the weighing data in memory or
outputs to a printer or personal computer
depending on the function table settings.
(Factory setting = output)
Sets the display to zero.
* When the "Gross net tare function" is selected, the display is turned off by pressing and holding
(for 2 seconds). Please refer to the separate instruction manual "16. Gross Net Tare Function".
When pressed and released
ON:OFF . The standby indicator is displayed when the display is
Press the key
(Press and release
the key immediately)
When pressed and held
ON:OFF key during
- Enters the function table mode.
Please refer to the separate
instruction manual "11. Function
Table".
- Runs the repeatability check function
when pressed and held for another 2
seconds after the function table
menu is displayed.
Please refer to the separate
instruction manual "22. Repeatability
Check Function".
(GX-M series only)
Displays other items of the calibration
menu. Please refer to the separate
instruction manual "8-2 Self Check
Function/Automatic Setting Of
Minimum Weighing Value by ECL".
Displays other items of the calibration
menu.
Enters mode to change the unit mass
registration number in counting mode.
By changing the function table:
- Outputs "Title block" and "End block"
for GLP, GMP report.
- Displays the data memory menu.
- Enters mode for reading density
number in flow measurement.
8
Press and hold
the key for 2
seconds
(for 2 seconds)