Wired Mode; Function Setup - Inateck BCST-33 Bedienungsanleitung

Use of Inateck BCST-33
EN
Startup

Wired Mode:

1. Connect Inateck BCST-33 with computer via USB cable
2. Inateck BCST-33 will continuously beep. Beep stops after successful connection.
3. Open a file on computer and move cursor to the blank where scanning output
should be placed. Scanning results can be displayed on computer then.
4. Scanning in the Hands-Free Mode
When the scanner is seated in the stand's "cup", the scanner's built-in sensor places
the scanner in hands-free mode. When you remove the scanner from the stand it
operates in its normal hand-held mode.

Function Setup

(Note: The barcode marked by "*"means default setting of Inateck BCST-33.)
Users must read setup barcodes in order to change the default settings in Inateck
BCST-33 Barcode Scanner.
2
Inserting and Using the Scanner in the Stand
Scan"Enter setup"barcode;
Change scanner setting by
scanning certain function
setup barcode;
Scan "Exit with save" barcode
to finish the setup.