CFH E-Bio Gartner EBG 666 Bedienungsanleitung Seite 13

Unsuitable extension cords can be dangerous. If an extension cable is used, it must be suitable for outdoor use and must
be dry and above the floor.
Connecting to the power supply
This unit is equipped with a cable holder to prevent the extension cord from being pulled out during use.
NOTE: Always use the cable holder to properly attach the extension cord to the unit. Not using the cable holder could
result in damage to the unit and/or the extension cable.
• Form a loop with the end of the extension cord.
• Pass the loop portion of the extension cable through the opening and place it over the cable holder.
• Slowly pull the strap against the cable holder until the slack is gone.
• Plug the extension cord into the machine.
NOTE: If the excess cable slack is not removed from the extension cable holder, it may cause the plug to be unplugged
from the socket.
Operation
Using the tool
Use with caution! Do not cover the vent openings during use.
There is a risk of burns! Never touch the hot nozzle!
Switch the device on:
• Switch on the tool by pressing the ON/OFF switch (4).
Switch the device off:
• Switch off the machine by releasing the ON/OFF switch (4).
Fitting the nozzle:
The conical nozzle (9) can be easily slid over the hot air nozzle. Never touch the hot air nozzle directly after using the device.
The hot air nozzle gets very hot.
Starting-up
First use:
• Always ensure that the tool is switched off.
• Slide a loop of the extension cable into the strain reliever in the handle, and secure it in the support provided.
• Fit the conical nozzle (9) to kill weeds.
• Use an extension cable to connect the tool to a power socket.
• Check that the nozzle is not blocked before you turn on the power.
• Switch on the tool by pressing the ON/OFF switch (4).
• Wait about 1 minute for the power tool to warm up.
• Kill the weeds by holding the nozzle (9) over the weeds for about 5 seconds. The cell structure of the weeds is destroyed
during these 5 seconds. This will result in the weeds dying within a few days.
• It is not necessary to burn the weeds completely, a few seconds are enough.
• For an efficient treatment, the nozzle should be kept 0 – 5 cm above the weeds.
• In addition, we point out that as a weed killer the E-Bio-gardener cannot achieve an immediately visible effect, but a so-
called long-term effect.
Warning! Ensure that the connecting cable does not come into contact with heat, oil or sharp edges. Damaged leads can
cause fires, short circuits and electrical shock.
Switching off:
• Release the ON/OFF switch (4).
• After use, always position the tool so that its stand (6) is on a flat, fireproof surface and allow the hot parts to cool down
completely.