CFH E-Bio Gartner EBG 666 Bedienungsanleitung Seite 12

h) Keep handles and gripping surfaces dry, clean and free of any oil or
grease. Slippery handles and gripping surfaces will not allow safe opera-
tion or controlling the power tool in unforeseen situations.
5. Service
a) Have your power tool repaired by specialist personnel and only use
original spare parts. This is to ensure the safety of the power tool.
Additional safety instructions
• ATTENTION! This tool must be placed on its stand when it is not being used.
• A fire might occur if the device is not handled carefully.
• Do not aim the tool at the same point for a long period of time.
• Pay close attention to the immediate working area and the area around it. The heat can reach flammable materials that
are not in the field of view.
• Be careful when using the device in the vicinity of flammable materials.
• Do not aim at the same point for a long period of time.
• Do not use this product in extremely dry places to prevent the risk of fire during its operation.
• Do not use it in an explosive atmosphere.
• Heat can be conducted to flammable materials that are covered up.
• Place the device on its stand after use, and allow it to cool down before you put it away.
• Never look into the hot air nozzle.
• Do not point the tool at people or animals when it is switched on.
• Do not hold the nozzle too close to the surface to be treated. This might cause the tool to overheat.
• The connecting cable or other flammable materials must not come into contact with the hot parts of the tool
• Do not leave the machine unattended when it is switched on.
• The unit should be always clean, dry and free from grease and oil.
• Always unplug the power cable from the wall socket when not using the unit, when you change the nozzles or when
doing maintenance.
• Do not use the tool for purposes other than those for which it is intended.
Before starting
Assembling the tool:
• The tool is delivered as a pre-assembled unit.
If the device is not used with care, there is a risk of fire! Please note the following:
• Remove all flammable objects, liquids and gases from the working area around the device before use. Keep the working
area clean to prevent accidents.
• Never leave the device unattended whilst it is operating.
During use of the device
• During use of the machine, vapours and gases may be released for a short time. This can be dangerous to your health. This
can be problematic especially for asthmatics.
• Always keep the power cable away from the nozzle.
• During use, keep children and pets away from this product at all times.
• Keep all parts of your body away from the heating element and heat shield (including the nozzle). Do not touch the hot
surface before it has cooled down completely. There is a risk of scalding!
• Hold the power tool by the insulated gripping surfaces only, because otherwise the heat shield (including nozzle) may
come into contact with hidden power lines or the tool's own power cable.
Switch off the device immediately in the following cases:
• If the plug or cable are damaged.
• If the switch is damaged.
• If smoke is coming from the machine due to burned insulation or if you can smell burning.
Replacing cables or plugs
If the connection cable is damaged, it must be replaced by the manufacturer or his service agent or a similarly qualified
person in order to avoid hazards.
Use of extension cords
Only use an approved extension cable that is suitable for the machine rating. The wires must have a minimum cross section
of 1.5 mm2 . If the cable is on a reel it must be completely unrolled.