CFH E-Bio Gartner EBG 666 Bedienungsanleitung Seite 11

c) Prevent an unintentional start-up. Make sure that the power tool is off
before connecting it to the power supply and/or the battery pack, pi-
cking it up or carrying it. If you have your finger on the switch when using
the power tool or if you plug the tool into the mains while it is on, this may
cause an accident.
d) Remove the adjusting key or wrench before turning the power tool
on. A tool or key inserted in a rotating part of the power tool can cause
injuries.
e) Avoid an abnormal posture. Ensure that you are standing firm and
keep your balance at all times. This means you can control the power
tool better in unexpected situations.
f ) Always wear suitable clothing. Do not wear loose clothing or jewelle-
ry. Keep your hair, clothing and gloves away from moving parts. Loose
clothes, jewellery or long hair may get caught in the moving parts.
g) If dust extraction and collection units can also be attached, they must
be connected and used correctly. Using a dust extractor can reduce dust
hazards.
h) Do not be lulled into a false sense of safety and do not ignore the sa-
fety rules for power tools, even if you are familiar with the power tool
after using it many times. Careless handling can cause serious injuries
within a fraction of a second.
4. Careful handling and use of power tools
a) Do not overload the power tool. Use the appropriate power tool for
your work. With the appropriate power tool you work better and safer in
the specified power range.
b) Never use a power tool that has a defective switch. A power tool that
cannot be turned on or off is dangerous and must be repaired.
c) Pull the plug out of the socket and/or remove the battery before you
change the device's settings, replace parts or store the tool. This pre-
caution prevents the unintentional start-up of the power tool.
d) Store power tools that are not in use well out of the reach of children.
Do not allow people who are unfamiliar with these instructions or
who have not read them to use the power tool. Power tools are dange-
rous when used by inexperienced people.
e) Maintain the power tool and operating tools with care. Check that
the tool's moving parts are working properly and do not jam, that no
parts are broken or damaged in such a way that the power tool cannot
be used correctly. Have the damaged parts repaired before using the
power tool. Many accidents are caused by badly-maintained power tools.
f ) Use the power tool, its accessories and attachments, etc. according to
these instructions. Take into account the working conditions and the
work to be done. Use of the power tool for purposes other than those in-
tended can result in hazardous situations.