clage Zip HydroTap MINIBOIL Gebrauchsanleitung Seite 20

Zip HydroTap MINIBOIL
®
4. Installation
Insertion: Removal:
Press collet
Push fully in
The following regulation must be observed:
• VDE 0100
• EN 806
• Installation must comply with all statutory regulations, as well as those of the local
electricity and water supply companies.
• The rating plate and technical specifications
Before installation, ensure that:
• There is enough space available for the undersink unit and the additional
ventilation (refer to installation drawing).
• A socket fitted with at least a 10 A fuse is available within reach of the power cord
and the socket will still be accessible after the unit has been installed.
• A water supply connection at the rated pressure of the appliance with an isolating
valve is available within reach of the feed pipe. The isolating valve must still be
accessible after the unit has been installed.
In addition to standard tools, the following special tools may be required:
• 35 mm diameter sheet metal hole punch for sink tops (not supplied)
• 35 mm diameter hole saw for timber worktops (not supplied)
• Pipe wrench (supplied) for fixing the tap
Handling the plastic hoses and push-fit connector (supplied):
• If shortening the hoses be sure to make a clean cut straight across the hose, using a
sharp blade. Never pinch off the hose with a blunt instrument.
• The hoses must not be under tension when installed. The minimum bending radius
Pull
tube
is 25 mm. If there is a kink in the hose, there is a risk of leakage at the kink.
• Push the hose into the quick­release connector as far as it will go (approx. 15 mm) to
ensure a tight connection.
16