Effect Chart - AER Domino 3 Bedienungsanleitung

Notes:
1. Input sensitivity
Input sensitivities refer to 2 x 85 watts into 4 ohms,
full gain and master settings, neutral tone control
settings, and 1 kHz sine-wave test signal.
2. Noise and dynamic range
Equivalent input noise voltage was obtained by
measuring noise voltage at speaker output and
dividing by the effective voltage gain of the amplifi-
er. Full gain and master settings, neutral tone control
settings, input shorted, measuring bandwidth
20 Hz – 20 kHz.
Dynamic range: Range between output signal at
limiter threshold and A-weighted output noise with
master volume in zero position.
3. Output levels
Output levels refer to 50 mV / 1 kHz sine-wave test
signal at channel 1 input in line mode, full gain and
master settings, and neutral tone control settings.
4. Options
he following options can be activated by jumper
settings. 9 V phantom power can be enabled for
channels 2 and 4 if required. (Not recommended
generally, because only a common switch will be
available for channels 1/2, and channels 3/4 respec-
tively) 48 V phantom power can be disabled for
each of the four channels.
DI output can be changed from post-equalizer to

7. Effect chart

number description
01 Long warm corridor
02 Xlarge marble church
03 Xlarge wood church
04 Large soft hall
05 Large bright hall
06 Mid vocal hall
07 Small dark room
08 Small soft room
09 Ambience delay
10 Swimmingpool
11 Phasing chorus
12 Frozen chorus
13 Ambient reflections
14 Long delay
15 Fast delay
16 Spacy delay
pre-equalizer (tone controls) for each channel, and
disconncted from aux in, internal, and external
effects.
Send level can be made dependent on eff. send
controls for each channel.
Rec out level can be made dependent on pre out
control.
0 dBV = 1 V
Specifications and appearance subject to change
without notice.
type
Reverb
Reverb
Reverb
Reverb
Reverb
Reverb
Reverb
Reverb
Reverb/Delay
Reverb
Chorus
Chorus
Delay
Delay
Delay
Delay
17