Fairland oku TurboSilence AquaX Installations- Und Gebrauchsanleitung Seite 16

UNIT=MM
AXR10V
AXR13V
AXR17V
AXR21V
AXR26V
AXR32V
AXR32VT
AXR40VT
2.2.2. Heat pump installation.
 The frame must be fixed by bolts (M10) to concrete foundation or brackets. The
concrete foundation must be solid; the bracket must be strong enough and anti-rust
treated;
 The heat pump needs a water pump (Supplied by the user). The recommended pump
specification-flux: refer to Technical Parameter, Max. lift ≥10m
When the heat pump is running, there will be condensation water discharged from the

bottom, please pay attention to it.
2.2.3. Wiring & protecting devices and cable specification
 Connect to appropriate power supply, the voltage should comply with the rated voltage
of the products.
 Well earth the heat pump.
 Wiring must be connected by a professional technician according to the circuit diagram.
 Set breaker or fuse according to the local code (leakage operating current ≤ 30mA).
 The layout of power cable and signal cable should be orderly and not affecting each
other.
A B
685 441
685 441
685 463
685 463
685 463
703 555
703 555
819 555
※
Above data is subject to modification without notice.
For installers and professionals
C D E
753 710 688
753 710 688
775 710 688
775 710 688
775 710 688
955 729 707
955 729 707
955 845 823
- 13 -
F G H
300 75.5 668
280 75.5 668
350 75.5 668
390 75.5 668
460 75.5 743
640 75.5 917
640 75.5 917
650 75.5 917