BOMANN DU 660 IX Bedienungsanleitung Seite 20

1
• The hood is mounted below a suitable wall unit. Determine the position of the extractor hood centrally The hood is mounted below a suitable wall unit. Determine the position of the extractor hood centrally The hood is mounted below a suitable wall unit. Determine the position of the extractor hood centrally
above the hob in conformance with the specified safety distances. conformance with the specified safety distances.
• Pull the pull-out device and remove
• Hold the hood to the specified cabinet
sponding to the six screw holes. Check
• For extraction mode, you must also
• If the mains cable is fed through the
• Drill six mounting holes of Ø 4 mm
• Screw in the appliance with the screws (1) ance with the screws (1) and washers under the wall unit.
• Insert the connecting piece with non
the mounting hooks on the connecting piece
• For extraction mode, a flexible extraction
fitted and connected to the outside
• To fill the gap between the wall and
depending on the gap. Mount the
• Reinstall the aluminum grease filter.
I I I I nstalling the activated carbo nstalling the activated carbon filter for recirculation mode
nstalling the activated carbo nstalling the activated carbo
• Pull the pull-out device and remove the aluminum grease filter.
• Place the carbon filter onto the air intake of the extraction duct. Make sure that the mounting pins on the Place the carbon filter onto the air intake of the extraction duct. Make sure that the mounting pins on the Place the carbon filter onto the air intake of the extraction duct. Make sure that the mounting pins on the
extraction duct engage the mounting slots of the carbon filter. Turn the respective filter clockwise u extraction duct engage the mounting slots of the carbon filter. Turn the respective filter clockwise u extraction duct engage the mounting slots of the carbon filter. Turn the respective filter clockwise until it
clicks into place.
• Reinstall the aluminum grease filter
NOTE NOTE NOTE: : : : NOTE
The activated carbon filter absorbs odours
2
move the aluminum grease filter.
cabinet position and draw the drilling points from the
Check them with a spirit level.
also create a feed through of approx. Ø 130 mm in
the unit, a feed through also must be provided.
Ø 4 mm through the base of the unit.
non-return valves (2) onto the extraction duct from
connecting piece latch into place.
extraction hose (not supplied) with an inner diameter
outside by an extraction vent.
and the appliance, attach the spacer strip (3) on t
strip using the screws (4) in the holes provided on
filter.
n filter for recirculation mode n filter for recirculation mode n filter for recirculation mode
n filter for recirculation mode n filter for recirculation mode n filter for recirculation mode n filter for recirculation mode
emove the aluminum grease filter.
um grease filter.
odours and must be replaced at least every six months
3
20
4
the inside of the unit corre-
the base of the unit.
from above. Make sure that
diameter of Ø 120 mm must be
(3) on the narrow or wide side,
on the appliance.
months regardless of use.