Bosch POF 1100 AE Bedienungsanleitung Seite 18

Routing with Parallel Guide
(Accessory – see figures
Slide the parallel guide 30 with the guide rods 31
into the base plate 12 and tighten at the required
measure with the wing bolts 16.
Guide the machine with uniform feed and side-
ward pressure on the parallel guide 30 along the
edge of the workpiece.
Routing Circular Arc Profiles
(see figures +
I
Reverse the parallel guide 30 (facing surfaces
point upwards) and insert the guide rods into the
base plate 12. Fasten centring pin 32 to parallel
guide (through hole) with wing bolt 33.
Puncture centring pin into marked centre of the
circular arc and guide router with consistent feed
across the workpiece surface.
Routing with the Curve Buffer
(see figures +
L
Slide the parallel guide 30 with the guide rods 31
into the base plate 12. Fasten the curve buffer 34
with the guide roller mounted to the parallel
guide 30.
Guide the machine along the workpiece edge
with light sideward pressure.
Routing with the Router Compass
(Accessory – see figure
Use the router compass/guide rail adapter 35
(accessory) for circular routing jobs.
Mount the router compass as shown in the figure.
Screw pointed centring screw 40 in thread. Insert
the point of the centring screw in the centre of the
circular arc to be milled and ensure that it en-
gages in the workpiece surface.
Coarse-adjust the required radius by positioning
the router compass, then tighten the locking
screws 37 and 38.
After loosening the locking screw 37, the router
compass can be reset with the fine adjustment
knob 39 (1 scale mark = 0.1 mm/1 rotation =
2.0 mm).
Lead the router over the workpiece, holding the
router with the right handle 19 and the additional
router compass handle 36.
18 • 1 609 929 F23 • 04.04
+ )
G H
)
K
)
M
)
N
Routing with Guide Rail
(Accessory – see figure
Working with the guide rail 42 is possible only
with use of the guide-rail adapter 35 (accessory).
Straight routing cuts are to be carried out with
help of the guide rail 42 (accessory).
For this, always use the base spacer 41 (acces-
sory) to compensate the height difference.
Mount the guide-rail adapter 35 with the guide
rods 31.
Place the guide rail on the workpiece and mount
with a suitable clamping device (e. g. screw
clamp).
Place the router with guide-rail adapter 35 on the
guide rail.
Maintenance and Cleaning
Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and the ventilation slots clean.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts orders,
please always include the 10-digit order number
given on the nameplate of the machine.
WARNING! Important instructions for con-
necting a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to
the following code:
strain relief
live = brown
neutral = blue
Do not connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this machine, it must
be disposed of safely.
English - 6
)
O
To be fitted
by qualified
professional only