Fanaway VEIL Bedienungsanleitung Seite 11

Fanaway Veil Installation Instructions
Your ceiling fan is controlled via the remote control. There are 4 buttons (HI, MED, LOW, OFF) to control the
fan speed and one button to control light on/off. Fig. 13
Before operating the remote, the following must be considered.
-
2 x AAA 1.5V (size) batteries are required to operate the remote control. Remove the battery cover
from the back of the remote and insert 2 x AAA batteries. Ensure the polarities are correct as shown
in the battery compartment. (Fig.11) (Batteries not included.)
-
The remote (transmitter) and receiver must be configured so that communication between each other
is paired up. This is achieved by setting the DIP switch on the receiver and remote on the same setting.
(Fig. 12)
Note: The DIP switch assembly has 4 switches which can be setup to 16 different transmitting code
combinations. This is practical when there is more than 1 remote/receiver pair operating locally or in
the same room.
Note: To access the receiver DIP switches, remove the DIP switch cover.
Fig. 11 Remote battery compartment
OPERATING THE REMOTE:
Before you start using the remote, take the time to read through this section and get familiar with the buttons
and function of each button.
LED Indicator
The red LED indicator on the top of the transmitter will flash when the buttons are active.
10 | P a g e
USING YOUR CEILING FAN
Fig. 12 Receiver DIP switch