AEG of 500 s Gebrauchsanleitung Seite 7

Adapter for guide
rails
(Accessory*
Part number:
4932 3618 66)
Advices for
operation
Maintenance
ENGLISH
Unscrew the parallel guide from its guide
rails and fix the adapter instead.
When the adapter is attached, the router
can be lead along the guide rail
(accessory). This makes exact cuts
possible.
Lead the machine steadily over the
workpiece, holding it with bouth hands.
Always work in counter rotation to cutter
(see illustration), otherwise danger of
backstroke!
For exact straight cutting, use the guide
rail.
Lenght 800 mm: Order No. 4932 3618 35
Lenght 1400 mm: Order No. 4932 3618
36
After removing the cage, the router can
be used as a straight grinder.
In connection with the flexible shaft
(accessory), it is possible to work in
places which are difficult to reach.
The ventilation slots of the machine must be kept clear at all times.
In order to guarantee constant readiness for operation, the machine should be
checked for worn carbon brushes at one of the AEG after–sales service agencies.
Use only AEG accessories and spare parts. Should components need to be
replaced which have not been described, please contact one of our AEG service
agents (see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please state the ten–digit
No. as well as the machine type printed on the label and order the drawing at your
local service agents or directly at: Atlas Copco Electric Tools GmbH, Postfach 320,
D–71361 Winnenden.
6
OF 500 S, OFE 710