AEG of 500 s Gebrauchsanleitung Seite 6

Mounting the
plastic protection
(Accessory*
Part number:
4932 3117 22)
Mounting the
flexible shaft
(Accessory*
Part number:
4932 3300 00)
Copying device
(Accessory*
Part number:
4932 2499 77)
Curve Gauge
(Accessory*
Part number:
4932 3132 74)
Circular Guide
(Accessory*
Part number:
4932 2499 80)
ENGLISH
Push the plastic protection into base plate
as shown in illustration.
Loosen the clamping screw of the motor
part and remove it from the cage.
Fix the motor part in the machine holder
(Order No. 4932 3192 27) and fasten the
machine holder on the workbench. The
machine can also be fixed with the screw
clamp (Order No. 4932 3018 06).
Fix the flexible shaft in the collet and
tighten the tension nut.
The machine has a max. speed of rotation of 34 000 min
ball–bearing AEG flexible shaft (Order No. see above).
For cutting shapes to a pattern (B)
the guide bearings (A) must be
screwed onto the base plate.
For outer contours the pattern (B)
must be smaller by measurement
(C), on inner contours it must be
bigger than the workpiece.
Further guide sleeves with an outer
diameter of 25–40 mm can be
obtained as accessory.
Unscrew the guide bars from the rip fence
and screw onto the curve gauge.
Push the shaft into oneof the drill holes for
the rip fence.Set the radius between the
central point and profile cutter and tighten
the capstan-head screw.
5
–1
. Therefore only use the
A
B
C
OF 500 S, OFE 710