AEG of 500 s Gebrauchsanleitung Seite 5

Setting of routing
depth
Revolving depth
gauge
Setting speed of
rotation
(only applicable for
OFE 710).
Table for
electronic
settings
On-/off switch
ENGLISH
1.
Lower cage until the router cutter
touches the workpiece
, and
tighten clamping lever .
2.
Lower the depth gauge onto the required
screw of the revolving depth gauge.
3.
Pick value off the scale, add required
routing depth, and set depth gauge at
estimated value .
4.
Loosen clamping lever, lower cage to
depth gauge and re–tighten clamping
lever.
It is advisable to cut in stages for larger cutting depths or larger cutter diameters.
Three cutting depths can be set with the screws on the revolving depth gauge:
1.
Set required cutting depths as described above, and set the depth gauge on the
shortest screw (lowest cutting level).
2.
Set the first two cutting depths on the longer screws. Tighten screws again and
secure with the locking nuts against distorting.
3.
For cutting, lower the cage to the longest screw and tighten. Turn the depth gauge
each time after cutting.
A = lowest r.p.m.
G = largest r.p.m.
Under the effect of extreme electromagnetic
interferences from the outside, tempo–rary variations in
the speed of rotation could arise in particular cases.
Router ø Router
in mm working
material
4–16 HSS
HSS
18–36
4–20 HM
22–36 HM
Switching on:
Slide back the On/Off switch. To lock,
depress the front part of the sliding switch.
Switching off:
To unlock, depress the back part of the
sliding switch. The switch will automatically
move back to "0".
4
Soft wood Panels
made of
wood chips
F–G –
–
E
G
G
F F
1
Plastic,
Perspex
D–E
C–D
E–F
D–E
OF 500 S, OFE 710
2
1
2