AEG of 500 s Gebrauchsanleitung Seite 4

Exchanging
collets
Parallel guide
Fine adjustment
(Accessory*
Part number:
4932 3115 84)
Sawdust removal
ENGLISH
The following collets can be used: ø 6 mm, ø 8 mm, ø 1/4"* (The ø relates to the
shaft diameter of the router).
1.
Unscrew adjusting nut completely with
collet (see also "Exchanging router
cutters".
2.
Pull out collet from adjusting nut.
3.
Push a new collet into adjusting nut until it
locks into position.
4.
Screw adjusting nut with collet onto
working spindle and tighten.
1.
Assembly of parallel guide as shown
in illustration.
2.
Insert parallel guide into the bores at
the base plate. After setting the
required distance from the edge
tighten the wing screws.
For close cutting of boards coated on one
or both sides, the plastic corner guides are
screwed on, as figure.
Insert the precision adjustment screw (B)
fromthe right or left into the base plate.
Adjust the cutting distance roughly and
tighten screw (A). By turning the screw
socket set the clearance exactly. Tighten
clamping screw.
Check the settings with a test cut and
make possible corrections with aid of
fine adjustment.
For sawdust removal, a suction hose can be attached to the suction device of the
machine. Industrial vacuum cleaners as well as household vacuum cleaners are
suitable.
Only operate the machine with suitable sawdust removal.
1.
Insert the suction device as shown in
illustration.
2.
Insert the suction hose into suction
device turning it slightly and connect
the other end of the hose with a
vacuum cleaner.
The suction device has a standardized
inner diameter of 26 mm. Any suction
hose with the same diameter can be
used (e.g. suction hose Id–No.
4932 3304 12).
3
A B
OF 500 S, OFE 710