Food Preparation; Use Of The Appliance - Hyundai JE 337II Bedienungsanleitung

ASSEMBLY
Insert the pulp container F into the holder. Slide the container B into the propulsion unit A all
the way. Put the sieve C onto the propulsion shaft A2 a secure it with slight pressure. Put the lid
D onto the container B and secure it by snapping the closures A3 (slide the upper parts of the
closures onto the protrusions in the grooves of the lid first and then snap in their bottom parts).
Pay special attention to this operation. The lid is now secured in the proper position and drive
unit A can work. Proceed reversely when removing the individual parts.
Note: If the lid D has been placed and secured incorrectly, the appliance will not turn on.

Food preparation

• The appliance is intended for processing almost all kinds of fruit and vegetables.
• Currant, bananas, avocado, figs, mango etc. are not suitable for processing in the juicer.
• Such fruits may be processed with fruit processing machine, mixer and flour-kneading
machine.
• Always use fresh, ripe fruits and vegetables which will give you more juice.
• Remove the stems and haulms.
• Wash the fruit or vegetables thoroughly.
• Cut bigger foods into smaller pieces.
• Remove pits (e.g. with plums, apricots, cherries, etc.)
• Remove thick skin (e.g. with melons, pineapples, cucumbers, potatoes, beet, celery, etc.)
• Peel citrus fruits and remove white pulp and seeds; otherwise the juice could turn bitter.
• Foods with thin skin do not need to be peeled (e.g. apples, pears, carrots, radish, parsley, etc.).
• Do not mince frozen fruit and vegetables.

Use of the appliance

Place the assembled juicer on a firm, flat and dry surface (see par.I. SAFETY PRECAUTIONS).
Openings in the appliance ensure the flow of air during ventilation and must not be covered or
blocked in any way. The feet of the appliance must also not be removed. Make sure that the
power supply cord is not damaged and that it does not lead through any sharp or hot surfaces.
The socket must be easily accessible so that it would be possible to unplug the appliance
immediately in case of danger. Plug the fork of the supply cord A4 into the el. outlet.
Place the container G without the lid G1 or another suitable container for juice.
Turn the appliance on by turning the switch A1 to desired position according to the food
processed.
- When processing soft/juicy food (e.g. apples, citrus fruit, tomatoes, etc.), turn the selector
to position 1 (low speed).
- When processing food with lower juice ration (e.g. carrots, parsley, etc.) and when
processing hard food (e.g. celery), turn the regulator to position 2 (high speed).
Feed the prepared food into the feeding opening D1 a push them slightly with the stamper E. Do
not push hard on the stamper, it could affect quality of the juice or even cause the appliance to
stop. Having finished using the appliance, turn it off, wait till the rotating sieve stops completely
and unplug the appliance from the outlet by pulling out the fork of the supply cord from the
socket. Before pouring the juice, put the lid G1 on the container G which will catch the foam.
BE SURE:
• Not to use excessive force to press the propeller, since such a way may influence the quality
of the juice, and may cause the filter to stop rotating as well.
• Never to stretch fingers or other objects into the feeding tube.
• When all the materials are processed up and there is no more juice flowing out, turn off the
juicer and pull out the plug, and wait till the filter stops rotating completely.
28 / 47