Interior Lighting - Klarstein VINAMOUR 12 UNO Bedienungsanleitung

EN
24

Interior lighting

The device has an interior lighting. The light can be switched on and off with the light
button.
Compartments
• The compartments can be adapted to the size and shape of the wine bottle.
• To avoid damaging the door seal, make sure the door is fully open before pulling
the compartments out of the machine.
• The compartments are factory fitted so that the wine bottles can be cooled in an
energy-efficient manner.
Before switching on
• Make sure that the machine is installed by a qualified person, following the
operating instructions.
• After installing the machine, wait four hours before plugging the power plug into
the wall outlet. This will allow the refrigerant to be completely redistributed in the
refrigerant circuit.
• Before using the machine for the first time, clean the exterior of the machine and the
removable accessories with a mild soap solution and water.
• Clean the inside of the appliance with a solution of sodium bicarbonate and water.
After cleaning, dry the inside of the appliance and the accessories properly.
• When you turn on the machine for the first time, a strange smell may appear. This is
normal and the smell disappears as soon as the unit starts to cool down.
During first use
Note: When you use the unit for the first time or switch it on again after a long period,
there may be a difference of a few degrees between the temperature you set and the
temperature displayed on the screen. This is normal. If the unit has been switched on
for a few hours, the temperature will adjust.
• The first time you switch on the unit, the compressor of the unit runs continuously until
the unit has cooled down.
• The appliance door should be opened as little as possible during the cooling down
process.
• If the unit has been switched off or the mains plug has been removed from the
socket, you should wait at least 5 minutes before switching it on again or plugging
the mains plug back into the socket.