Installation; Tools Required; Assembly Illustrations; Of The Instructions) - Sentiotec Onni Small Benutzerhandbuch

Instructions for installation and use

4. Installation

Before you begin work, check the parts list to ensure that all the individual parts
have been delivered. If any parts are missing, please contact your dealer within
14 days of receiving the cabin – see warranty card at the end of the instructions.
You need an assistant for assembly.
We also advise you to pre-drill the holes for the screws.
Check the right angle:
80 cm
Handle glass with care: Special care must be taken with the edges of
the glass – hardened glass can shatter into small pieces in the event of
impact. Insert protective cushioning (e.g: cardboard box) under the edge
of the glass.

Tools required

Screwdriver
Twist drill bit
Spirit level

5. Assembly illustrations

the instructions)
page 11
Tape measure
Utility knife
Pencil
(following the last language of
p. 7/10
EN
Drill
Step ladder