Cleaning And Care - Klarstein SANTA ELENA Bedienungsanleitung

CLEANING AND CARE

• Always disconnect the appliance from the power supply before cleaning the
appliance or carrying out maintenance work.
• Never use a wet sponge to clean the appliance.
• In order not to damage the product, it is advisable to use equipment adapted to the
sensitive surfaces and products, which will slow down the wear of the device.
TROUBLESHOOTING
Problem Possible cause
The fan does not Fuse or circuit breaker blown.
start.
Loose cable connections.
Speed was not set correctly.
The fan makes The upper cap touches the
noise. ceiling.
Screws of rotor blades are
loose.
Ceiling fan is not properly
attached to the ceiling.
Speed is not adjusted
correctly.
The fan is Rotor blades are not adjusted
wobbling. horizontally to the ceiling.
Screws of the rotor blades are
loose.
Approach
Check your fuses.
Check all connections for
loose cables.
Select a speed.
Make sure there is a minimum
distance of 3 mm between the
top cap and the ceiling.
Tighten all screws.
Tighten all screws in the
suspension plate.
Select a speed.
Move the fan so that all
blades are at the same height
to the ceiling.
Tighten all screws.
EN
21