Skan Holz Varberg 3 Bedienungsanleitung

Varberg 3 570 x 525cm
Important information
We are pleased that you have chosen a product of SKAN HOLZ.
Please check the construction set for completeness using the position list in good time before starting con-
struction or commissioning your construction team. If individual parts are defective or missing, we will deliver
these as quickly as possible. However, we cannot refund the costs for any resulting construction delays to a
construction company.
Please understand that we cannot assume any guarantee for the following defects:
- incorrect storage before assembly
- incorrect anchoring with the ground or inadequate foundation (foundation according to statics)
- damage due to erection errors, e. g. the house is not level or not right-angled
- damage through a higher level of snow burden than statically envisaged. Recommendation: lad relief of
the roof by removing the snow layer
- storm damage (insurance cases) or violent destruction
- damage through any alteration to the design by the client
- natural formation of cracks, branch holes, twisting, decolouration or similar modification (natural
process; has no influence on the statics)
Storage information until construction :
- store pallet on a level and dry surface.
- Protect from exposure to sunlight and the influences of weather ; wood can warp drastically in a loose
condition!
Maintenance tips:
Please observe the attached information sheet "Care instructions/Colour treatment".
General tips and refers to:
-
1 Given that the roof is constantly exposed to the weather, a covering with only one layer of roofing paper will not
be enough over the long-term. An additional covering with bitumen shingles, alternatively with a material of at
least equivalent quality, must follow.
-
Foundation according (to the structural calculations, not included in the scope of delivery):
1
concrete C25/30, strip foundation: w/h = 30/90cm, each 2 Ø 12 top and bottom, bow Ø 6, e < 20cm. Bottom
panel: t=14cm,Q188A, top and bottom throughout. Anchoring of the floor beams on the strip foundation using
bolts M12, e < 60cm (by customer).
-
2
The wooden parts of the building kit are delivered with a residual moisture content of about 15%.
Wood "works"! This means that the wooden parts will swell during prolonged damp weather and shrink (dry out)
during prolonged dry periods. This only occurs in height or width, not lengthwise. The block planks are firmly
screwed to the vertical corner post during installation. This will not change its length, but the horizontally attached
planks change their height. If damp weather persists, the block planks can swell slightly after completion. It is
therefore important to leave 1mm clearance between the planks when fitting. Use the enclosed spacer (to avoid
unnecessary strains in the structure).
-
3
If the door does not close correctly, this can be readjusted by rotating the hinges in the door leaf and door
frames.
© SKAN HOLZ Europe GmbH D-21227 Bendestorf. Technical modifications reserved. All dimensions are approximate dimensions. Date 06/20
247172 (unbehandelt)
247172-13 (schiefergrau)
247172-15 (schwedenrot)
1