Manual Code Search - Hama 00012306 Bedienungsanleitung

Note
• Each type of device can be programmed under any
device key, e.g. a TV can be programmed under
DVD, AUX, etc.
• You cannot operate a device with the universal
remote control while it is in Setup mode. Exit Setup
mode and select the device to be operated using
the device selection buttons.
• Please note that the remote control emits infra-red
signals. These are not visible to the human eye.
5.1 Direct code entry
A code list is included in the universal remote control's
extent of delivery. The code list contains four-digit codes
for setting the remote control to work with most AV
equipment manufacturers.
For easy orientation, the codes are sorted rst by type
of device (TV, DVD, etc.) and within the type of device
alphabetically by brand name.
5.1.1 Switch the device you wish to operate on.
5.1.2 Press the "SETUP" button until the LED lights up
continuously.
5.1.3 Use the device button to select the device to be
operated (e.g. TV). If the selection is successful,
the LED flashes once and then lights up
permanently.
5.1.4 Search the code list for the brand and type of the
device to be operated.
5.1.5 Enter the corresponding four-digit code using the
number keys 0-9. The LED confirms the entry of
each digit with a short flash and goes out after
the fourth digit.
5.1.6 Then test the remote control and check whether
the desired functions can be controlled. It is
possible that the first code is not the most
suitable, and possibly not all functions are
available. In this case, try the next code
mentioned for the selected device type/brand
from the list.
8
Note
• A valid code is automatically saved.
• If the code is invalid, the LED ashes six times and
then goes out. Repeat steps 5.1.1 to 5.1.5, or use
another method to enter the code.

5.2 Manual code search

The universal remote control has an internal memory
that already contains up to 350 codes per device type for
the most common AV devices. You can go through these
codes until the device to be operated shows a response.
For example, the device to be operated switches off
("POWER" key) or changes channel ("PROG+/PROG-"
key).
5.2.1 Switch the device you wish to operate on.
5.2.2 Press the SETUP button until the LED lights up
permanently.
5.2.3 Use the device button to select the device to be
operated (e.g. TV). If the selection is successful,
the LED flashes once and then lights up
permanently.
5.2.4 Press the "POWER" or "PROG+/PROG-" key to
scroll through the preset codes until the device to
be operated shows a response.
5.2.5 Press "OK" to save the code and exit the code
search. The LED goes out.
5.2.6 Then test the remote control and check whether
the desired functions can be controlled. It is
possible that the first code found is not the
most suitable, and possibly not all functions are
available. In this case, repeat steps 5.2.1. – 5.2.5.
The code search starts with the next code
following the last one saved.
Note
• A maximum of 350 codes of the most common
devices can be stored in the internal memory.
Due to the numerous AV devices available on
the market, it may happen that only the most
common main functions are available. If this is the
case, repeat steps 5.2.1 to 5.2.5 to nd a more
compatible code. A code may not be available for
some speci c device models.