Specifications; Description Of Your Kettle; Maintenance And Cleaning; Descaling - FAR BSF CNX15 CI Bedienungsanleitung

ENGLISH
• For the maintenance and cleaning
of your kettle, refer to the chapters

"MAINTENANCE AND CLEANING".

SPECIFICATIONS

Model:
Voltage:
Power:

DESCRIPTION OF YOUR KETTLE

BEFORE USING FOR THE FIRST TIME
Before using the kettle for the first time, it is recommended that you clean it by
boiling water twice up to max. level and throwing this water away.
Operation
1. To fill the kettle with water, remove it from its base, open its lid by lifting the
handle on the lid, then pour the desired quantity of water into the kettle. Always
fill the kettle between the minimum (0.5 l) and maximum (1.5 l) marks. If there is
not enough water in the kettle, it will switch off before the water has boiled.
NOTE: Never exceed the maximum mark when you fill the kettle, otherwise there
is a risk of splashing of boiling water through the spout. Make sure that the lid is
securely closed before connecting the power cord to an electrical outlet.
2. Close the lid. Place the kettle on its base. Make sure the kettle is fully in contact
with its power supply base.
3. Plug the base into a mains socket. Push the switch down to the "I" position,
the light will turn on and the appliance will start heating the water. The kettle
automatically turns off once the water has boiled and the light goes out. You can
press the switch at any time during the heating process to turn the kettle off.
NOTE: Make sure that the lid is correctly locked in place and that nothing
obstructs access to the switch. The kettle may not automatically switch off if its
switch is stuck or if its lid is left open.
4. Lift the kettle from its power supply base and then pour the water that it contains.
NOTE: Take care when pouring water out of your kettle, as boiling water can
cause scalding. Do not open the lid while the water in the kettle is hot.
GB-6
FAR BSF CNX15 CI
230 V ~ 50 Hz
1850 - 2200 W
5. The kettle cannot boil the water again as long as its switch has not returned to the
up position. Let it cool down for 15 to 20 seconds before re-opening the lid to boil
more water. The kettle can be stored on its power supply base when it is not being
used.
NOTE: Make sure that the power supply is cut off when you are not using the
kettle.
Dry-boil protection
If you inadvertently use the kettle with no water in it, the dry-boil protection system
will automatically switch it off. If this happens, leave the kettle to cool down before
filling it with cold water and boiling it.
MAINTENANCE AND CLEANING
Before cleaning the kettle, always unplug it from
the electrical outlet and wait until it has cooled
completely.
Never immerse the kettle or its power cord in
water and make sure that they never come into
contact with water.

DESCALING

The minerals found in tap water can build up inside your kettle. To remove these
deposits, use a non-toxic limescale remover.
Another way to descale your kettle:
1. Fill the kettle with 3 cups of white vinegar and top up with water. Leave to stand
for a whole night. Do not boil it.
2. Empty the kettle. Remove any remaining residue in the spout by wiping with a
damp cloth. Fill the kettle with fresh water, boil it, then tip the water away. Repeat
this process. The kettle is now ready to be used again.
ENGLISH
GB-7