Troubleshooting - Klarstein HAPPY HOUR Bedienungsanleitung

EN
20
• After plugging the appliance, allow the unit to cool down for 2-3 hours before
placing beverage into the refrigerator compartment.
• Ventilation is very important for this kind thermoelectric refrigerator; The inside
PCB will be broken easily if the ventilation is bad; It will also reduce the life of the
refrigerator.
• The refrigerator applies automatic defrosting system, so there is no need to defrost it
manually.

TROUBLESHOOTING

Problem
Appliance does not work.
The food is too warm.
Appliance cools too much. Temperature is set too cold. Turn the temperature
Unusual noises.
Possible cause
Mains plug is not plugged
in or is loose
Fuse has blown or is
defective
Temperature is not properly
adjusted.
Door was open for an
extended period.
A large quantity of warm
food was placed in the
appliance within the last
24 hours.
The appliance is near a
heat source.
Appliance is not level.
The appliance is touching
the wall or other objects.
A component, e.g. a
pipe, on the rear of the
appliance is touching
another part of the
appliance or the wall.
Solution
Insert mains plug.
Check fuse, replace if
necessary.
Please look in the initial
Temperature Setting
section.
Open the door only as
long as necessary.
Turn the temperature
regulation to a colder
setting temporarily.
Please look in the
installation location section.
regulation knob to a
warmer setting temporarily.
Re-adjust the feet.
Move the appliance
slightly.
If necessary, carefully bend
the component out of the
way.