Electrical Connection - EWT QUBE Bedienungsanleitung

y of
SPECIFICATIONS
ng or
Model
EAN code
has
Power
Thermostat
Heat Settings
Fan Mode
sible
Handle
Overheat protection
Anti-tilt protection
on a
Voltage
Frequency
Product dimensions (WxDxH)
Product weight
p pile
ugs,

ELECTRICAL CONNECTION

away
ace.
Only plug the appliance onto a 230-volt alternating current power supply (respect the indications on the identification
such
plate) and to an electrical installation which complies with the relevant standards. Please read the safety and installation
instructions carefully prior to switching the appliance on.
ings
rear
INSTRUCTION FOR USE
er to
Heat control – Switch Knob (See 2, Fig. 1)
eater
are
able
own,
n is
f fire,
other
Thermostat control knob (See 3, Fig. 1)
mum
tlet.
s to
in a
the
the
When the heat control is set to
Position
Qube2MB_A5_ZW.indd 12
OFF
Cool Blow*
Half Heat
Full Heat
The heat output is controlled by the thermostat.
Turn the thermostat knob fully clockwise to maximum setting initially. When the room is warm
enough, reduce the setting slowly until the heater just clicks off.
The heater will now cycle on and off to maintain your selected room temperature.
An audible click may be heard when the thermostat operates - this is normal.
Note: If the heater does not come on when the thermostat is at a low setting, this is normally
because the room is warmer than the thermostat setting and is not a fault.
for cool blow, set the thermostat control (3) to maximum.
will turn the heater on and off to maintain a temperature of approximately 5°.
W25.1 x D14.9 x H28.9 cm
Arrêt
Air frais*
Mi-chau age
Plein chau age
FR EN DE NL PL
QUBE2MB
3 461 710 000 013
2000 W
Electromechanical
2 : 800W / 2000W
Yes
Yes, leather effect
Yes
Yes
230-240V~
50Hz
1.7 kg
20/07/20//30 16:01 20/07/20//30 16:01
SV
12