Remote Access; Remote Access Authorisation Code; Toll-Free Remote Pre-Access; Remote Access Facilities - AUDIOLINE AB868 Bedienungsanleitung

5

Remote access

5.1

Remote access authorisation code

Your answering machine has personal access authorisation (Remote Code) so that
only you can listen to incoming messages using the remote access facility. The
authorisation code is a three-digit number and can be found on the underside of your
unit (Remote Code).
5.2

Toll-free remote pre-access

Using the toll-free remote pre-access facility, you can find out whether there are any
messages on your answering machine without incurring any charges.
Set the slide control to the "TS" position. If you now call your machine when you are
away, the answering machine answers as follows:
A. If your call is answered after 2 rings, there are messages on your answering
machine and you can continue as described under 5.3.
B. If no messages have been recorded, your call will not be answered after 2 rings.
Put the receiver down directly after the third ring as your answering machine will
switch on as normal after the sixth ring. In this way, you can save call charges.
5.3

Remote access facilities

Call your own telephone number and allow the greeting message to run through
to the end. Wait until your answering machine is ready to record a message.
After the signal tone, enter your personal authorisation code by pressing the
appropriate numbers on a telephone.
Two signal tones confirm that the right code has been entered. Now select one of the
functions listed below by pressing the appropriate combination of keys. The pause
between entering the individual functions must not exceed 20 seconds as, otherwise,
the connection will be cut off automatically.
Replay all recorded messages
Replay newly recorded messages
32
- Remote access -
Press 2 and #
Press 2 and 5