Commissioning; Before Commissioning; Check Contents Of Pack; Fitting The Battery (Not Included) - AUDIOLINE AB868 Bedienungsanleitung

3

Commissioning

3.1

Before commissioning

NOTE! Before commissioning, it is essential that you read the general instructions at
the beginning of this manual.
3.2

Check contents of pack

The following items are supplied:
one answering machine
one telephone connection cable
3.3 Fitting the battery
Before connecting your new answering machine to the telephone network, the battery
should be fitted. Please always use a new 9V alkaline block-type battery. The battery
is required for preventing loss of data if there should be a mains power failure.
Note: When the message bL appears in the display, the battery is run down and
must be changed.
1. Make sure that the answering machine is not connected to the telephone
network.
2. The battery compartment is to be found on the underside of your answering
machine.
3. Open the battery compartment with a small screwdriver.
4. Connect the battery plug to the battery and place these in the battery
compartment.
5. Close the battery compartment.
3.4

Connecting the telephone cable and power supply

Connect the small plug of the telephone cable supplied to the telephone socket on the
rear of the answering machine and connect the other end to your TAE socket (code N
= for additional equipment such as answering machine / telefax). Plug the power
supply into a properly installed mains socket and the other end into the socket on the
rear of the answering machine.
When switching on for the first time, your new answering machine needs a few
seconds to initialise all the functions. After initialisation, the display will show the
message 00. If no battery has been fitted, this alternates with the message bL.
26
- Commissioning -
one main power supply
one Operating Manual
(not included)