3M DBI-SALA Flexiguard M100 Handbuch Seite 11

Eye as possible. See Figure 9 for reference. Leaving the Safe Working Radius to an Outside Location (B) is dangerous
and could result in serious injury or death. When working on either side of the M100 Jib System, keep the anchor point
as close overhead as possible. If a rotation stop is in place on the jib mount, never work past that rotation stop. See the
User Instructions for the M100 Jib Boom (5908371) for more information.
4.0 INSPECTION:
;
After product has been removed from service, it may not be returned to service until a Competent Person confirms
in writing that it is acceptable to do so.
4.1 INSPECTION FREQUENCY: The Counterweight Base shall be inspected by the user before each use, and additionally
by a Competent Person other than the user at intervals of no longer than one year. A higher frequency of equipment use
and harsher conditions may require increasing the frequency of Competent Person inspections. The frequency of these
inspections should be determined by the Competent Person per the specific conditions of the worksite.
4.2 INSPECTION PROCEDURES: Inspect this product per the procedures listed in the "Inspection and Maintenance Log".
Documentation of each inspection should be maintained by the owner of this equipment. An inspection and maintenance log
should be placed near the product or be otherwise easily accessible to users. It is recommended that the product is marked
with the date of next or last inspection.
4.3 DEFECTS: If the Counterweight Base cannot be returned to service because of an existing defect or unsafe condition,
then either destroy the system or contact 3M or a 3M-authorized service center about possible repair.
4.4 PRODUCT LIFE: The functional life of the Counterweight Base is determined by work conditions and maintenance. As
long as the product passes inspection criteria, it may remain in service.
5.0 MAINTENANCE, SERVICE, and STORAGE
5.1 CLEANING: Periodically clean the metal components of the Counterweight Base with a soft brush, warm water, and a
mild soap solution. Ensure parts are thoroughly rinsed with clean water.
5.2 SERVICE: Only 3M or parties authorized in writing by 3M may make repairs to this equipment.
5.3 STORAGE: If applicable, store the Counterweight Base and associated Fall Protection equipment in a cool, dry, clean
environment out of direct sunlight. Avoid areas where chemical vapors may exist. Thoroughly inspect components after
extended storage.
6.0 LABELS and MARKINGS:
6.1 LABELS: Figure 12 illustrates labels present on the Counterweight Base. Labels must be replaced if they are not present
or fully legible. Information provided on each label is as follows:
1) Do not use the Counterweight Base without the counterweight attached.
A
2) Use of the Counterweight Base with Jib Boom is approved only with the counterweight attached.
1) Notified Body and Applicable Standards
2) Read all instructions.
3) Company Logo
4) Applicable Standards
B 5) Warning Instructions
6) Weight of filled Counterweight Box = 3,095 lb. (1,404 kg)
7) Weight of main base = 1,100 lb. (499 kg)
8) Maximum Weight of M100 Jib Boom = ≤805 lb. (365 kg)
9) Weight of Counterweight Base + M100 Jib Boom = ≤5,000 lb. (2,268 kg)
1) Manufactured (Year/Month)
2) Model Number
C
3) Serial Number
4) Company Logo
11