Lighting Instructions; Cleaning And Maintenance - RUSTA Executive 4+1-burner Gebrauchsanweisung

LIGHTING INSTRUCTIONS

1. Open the hood and make sure all the burners are closed.
2. Connect the regulator to the gas cylinder. Open the gas cylinder's valve to release
the liquefi ed petroleum gas.
3. Press down on the knob on the barbecue and turn it counterclockwise to the MAX position.
This releases the liquefi ed petroleum gas.
4. If the burner does not light within 5 seconds, turn the knob to the off position and
close the valve on the gas cylinder. Wait 3 minutes and then repeat steps 2, 3 and 4.
5. When the barbecue is lit, repeat step 3 for the barbecue's other burner.
6. Close the door on the barbecue and let the barbecue warm up to the desired temperature.
7. Turn the knob between MAX and MIN to adjust the heat.
8. To turn it off , turn the gas cylinder's valve to the closed position and then turn the
knob on the barbecue clockwise to the off position.

CLEANING AND MAINTENANCE

• Let the barbecue/barbecue parts cool completely before cleaning them.
• Make sure the fuel supply on the gas cylinder is closed.
• The grease/oils that collect in the bottom of the barbecue, the drip plate and heat
distributors must be cleaned from the barbecue regularly, otherwise there is a
signifi cant risk of the fat catching fi re.
• Clean the interior and exterior of the barbecue and the drip plate thoroughly and
regularly.
• The must be thoroughly cleaned regularly. If the barbecue is used in excessively
corrosive environments, such as by the sea, it is extra important that the barbecue be
cleaned often. Salt and moisture usually break down the barbecue's protective outer
surface, which can lead to surface rust.
CLEANING THE OUTSIDE OF THE BARBECUE
• Wipe the outside of the barbecue with a soft sponge, a mild soap and water. Rinse
with clean water and let it dry. Do not use abrasive cleaners.
• If there are any scratches/damage on the lacquer, it must be treated immediately to
make sure it does not start to rust. Treat any scratches/damage on the lacquer by
fi rst rub away any rust and removing any paint fl akes with a wire brush. Then paint
with rust protection paint for metal in the relevant colour. Always follow the instruc-
tions on the paint tin.
CLEANING THE INSIDE OF THE BARBECUE
• Remove the grill rack.
• Wipe the barbecue with a mild soap and water. Rinse with clean water and let it dry.
Do not use abrasive cleaners or oven cleaners.
• Before barbecuing, you can oil the grill rack with cooking oil so that the grill items do
not stick.
IM_623514690101_623514690102_Executive4_1_v1.indd 5 IM_623514690101_623514690102_Executive4_1_v1.indd 5
5
2020-09-11 16:46 2020-09-11 16:46