Herunterladen Inhalt Inhalt Diese Seite drucken

Gas Cylinder; Checking For Leaks; Frequently Asked Question - RUSTA Executive 4+1-burner Gebrauchsanweisung

4+1-burner
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

ENG

GAS CYLINDER

• Maximum gas cylinder size is H:800 x W:350 mm.
• The gas cylinder must not be dropped or handled carelessly.
• If the barbecue is not used, the gas cylinder must be disconnected and the safety cap
mounted.
• The gas cylinder must never be placed so that it is exposed to temperatures over
50° C. Therefore, do not place the gas cylinder directly under the barbecue. The gas
cylinder must also never be placed or stored in places where there is a risk of fi re
or sparks, for example.
• Do not smoke in the immediate vicinity of the gas cylinder.
• It is prohibited to make any modifi cations to the gas cylinder. This can be fatal.
CONNECTING THE GAS CYLINDER TO THE BARBECUE
• Make sure the gas cylinder's valve is closed.
• Connect the regulator to the gas cylinder.
• Connect the hose to the barbecue's connector.
• Make sure that the hose is not clogged, knotted or lying against any part of the barbe-
cue other than the connector.
• Check for leaks in the gas cylinder, regulator, hose and barbecue before starting to
barbecue. See the section "Checking for leaks".

CHECKING FOR LEAKS

• Mix 50% soap with 50% water. Make sure that the gas valve on the gas cylinder is
closed and that the pinion on the barbecue is closed.
• Put a soap solution on the gas cylinder's valve, the regulator, the hose and the connector
to the barbecue.
• Open the gas valve on the gas cylinder. If there are small bubbles in any of the pre-
viously mentioned parts, this means that there is a leak.
• Close the gas valve and tighten the hose connectors. Perform the test again. If there
is still a leak, contact your Rusta warehouse.
BURNERS

FREQUENTLY ASKED QUESTION

Why is there no seal between the burner and valve?
Answer: To burn correctly, the LPG needs to be mixed with oxygen, this is done where
the valve joins the burner. To avoid poor combustion, the joint must not be sealed.
4
IM_623514690101_623514690102_Executive4_1_v1.indd 4
IM_623514690101_623514690102_Executive4_1_v1.indd 4
Valve
Gas
Oxygen
Burner hose
2020-09-11 16:46
2020-09-11 16:46

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

623514690101623514690102

Inhaltsverzeichnis