Outstanding Risks; Declaration Of Conformity - WOLFF Vacuclean 2 Original Bedienungsanleitung

2.4

Outstanding risks

Careful analysis of risks performed by the manufacturer and stored in the technical file has made it possible to
eliminate most of the risks associated with vacuum cleaner operation.
The manufacturer advises carefully following the instructions, procedures and advice contained in this manual as
well as applicable safety regulations, including the use of the envisaged protection devices, both those integrated
in the cleaner and individual.
Outstanding risks associated with the vacuum cleaner could be:
Electrical maintenance risks caused by the need to work under power.
Pursuant to Presidential Decree 81/08, only trained personnel should work on the machine with the power supply
connected and this must have double earth insulation.
Risk of improper use in the presence of explosive and flammable substances.
The vacuum cleaner must not be used in environments containing substances in the form of liquids that could
vaporise at room temperature and flammable dusts and gas.
Risks of operation in humid environments.
Keep to the limits shown in this manual at chap. 1.6 Allowed environmental conditions.
Risk of erroneous interpretation of the safety pictograms.
Having identified the various outstanding risks, the manufacturer has affixed to the cleaner a number of hazard
labels in compliance with regulations relating to the graphic symbols to be used. The user must immediately replace
any safety plates that become illegible due to wear or damage.
Attention!
Removing the safety plates on the vacuum cleaner is strictly forbidden. The manufacturer declines all liability in
relation to vacuum cleaner safety in the event of failure to comply with the above indications.
2.5

Declaration of Conformity

We declare under our sole responsibility that this product is in conformity with the following standards of
standardization documents: DIN EN 60204-1, DIN EN 61000-3-2, DIN EN 61000-3-3,
DIN EN 55014-1, DIN EN 55014-2, according to the provisions of the: 2006/42/EG, 2004/108/EG, 2006/95/EG.
16.05.2016 i.V.
Authorised to issue this declaration and for the gathering of the technical documentation.
Uzin Utz Tools GmbH & Co. KG | D-74360 Ilsfeld | Ungerhalde 1
Uzin Utz Tools GmbH & Co. KG | D-74360 Ilsfeld | Ungerhalde 1 | Tel. +49 (0)7062-91556-0 | Fax +49 (0)7062-91556-10
E-Mail tools@uzin-utz.com | Internet www.wolff-tools.de
Dipl.-Ing. (FH) Dieter Hammel
15