ADE BA 1402 Bella Bedienungsanleitung Seite 32

1. Programming / Inputting personal data
Prior to first use your personal data such as sex (male or female), age and height must
be entered and stored in one of the storage cells P0 – P9 (for up to 10 people). The
scales make use of highly sensitive sensor buttons (Sensor Touch). The touch keys are
located below the display. To enter your personal data use the buttons:
and memory button), ‚ (up button),  (down button) and follow the individual
points:
Gently touch the SET button. "P0" will blink on the display. To choose the desired
1.
storage cell (P0 – P9), touch the  - or
button.
2. After you have chosen the storage cell (e.g. storage cell P3), the symbol for sex will
blink. To choose the desired sex ( male or
and then save by touching the SET button.
3. After you have chosen your sex (e.g.
display (default age 30). In order to enter your age, touch the
then save by touching the SET button.
4. After you have entered your age, the indicator for height will blink on the display
(default 170 cm). In order to enter your height, touch the
save by touching the SET button.
After you have finished entering your data, "0.0 kg" will appear on the display. The scales
are now ready and you can undertake a body analysis. Without further activity the scales
deactivate automatically after a few seconds. Your personal data has been saved.
If you touch the SET button again within 2 seconds after the first input, you can
immediately enter the data of other people, and for a new entry you will repeat
completely the steps mentioned above.
2. Weighing function (weight measurement only)
1. The scales have a step-on function. Simply step onto the scales, keep still and do
not hold onto anything.
2. After the scales have stabilised, your weight will be flashed at you three times in
succession and then be shown to you steadily for approximately 10 seconds.
3. After weighing, step off the scales. After a few seconds the scales will deactivate
automatically.
SET (power-on
‚ - button and then save by touching the SET
 ‚
female), touch the - or - button
male), the indicator for age will blink on the
 ‚
- or - button and
 ‚
- or -button and then
4
3. Body analysis
An analysis is only possible when you are barefoot. The personal data must be entered
beforehand (see page 4).
1. Activate the scales by touching the SET button. On the display the personal data of
the last setting will appear first. If this is not your data, choose the storage field under
which you saved your personal data using the
be shown. Confirm each of these by touching the SET button, after which the scales
will return to "0.0 kg".
Now stand carefully on the scales, barefoot with your feet left and right on the stainless
2.
steel strips (measuring units), and remain still.
3. First you will be shown your weight. After that, while the body analysis is being carried
out, the signal "o" will run on the display. Remain standing still. After the measurement
has been taken the measured values will be shown to you on the display:
Your body weight in kg
1. Your proportion of body fat in %
2. Your body water in %
3. Your muscle mass in %
4. Your bone mass in kg
*** While the proportion of body fat is being shown, at the very bottom of the display
appears an evaluation:
= fat proportion too low,
= fat proportion in healthy range
= fat proportion elevated
= fat proportion too high
After that your measured values (weight, body fat, body water, muscle mass and bone
mass) will be shown to you in turn, 3 times in succession.
EXAMPLE:
Weight Measurement Body fat
process
 - or ‚ -button. Your personal data will
(FAT) ***
(TBW)
(MUS)
(BONE)
Body water Muscle mass
5