LG CRD-8161B Bedienungshandbuch Seite 11

MOUNTING THE CD-ROM DRIVE
Figure 6. Removing the Floppy Disk
Drive and the Blanking plate
Figure 7. Mounting the Drive
Pin assignment
The pin assignment of the power-in
connector is as follows:
5V DC
Power supply connector
(4-pin connection cable)
Figure 8. Connecting the Power
Supply Cable
12V DC
GND
E-11
Step 1. Turn off and unplug your
computer and all peripheral
devices attached to it.
Step 2. Remove the cover from your
computer.
Step 3. Remove the front panel from an
unused half-height slot.
Step 4. Slide the CD-ROM drive into the
half-height slot, and secure the
drive in place with screws and
brackets.
Note: If there is too much space between
the sides of the drive and the drive
bay, you may need to install spacer
brackets, available at your local
computer store.
Step 5. Push the power supply cable
connector firmly into the power in
connector.