LANCOM GS-2124 Bedienungsanleitung Seite 160

When you enter this command via Telnet connection, you would logout
the system and disconnect. If you connect the system through direct serial
port with RS-232 cable, you would logout the system and be back to the
initial login prompt when you run this command.
Argument:
None.
Possible value:
None.
Example:
GS-2124L# logout
restore default
Syntax:
restore default
Description:
When you use this function in CLI, the system will show you the
information "Do you want to restore the default IP address?(y/n)". If you
choose Y or y, the IP address will restore to default "192.168.1.1". If you
choose N or n, the IP address will keep the same one that you had saved
before.
If restoring default successfully, the CLI would prompt if reboot
immediately or not. If you press Y or y, the system would reboot
immediately; otherwise, it would be back to the CLI system. After restoring
default configuration, all the changes in the startup configuration would
be lost. After rebooting, the entire startup configuration would reset to
factory default.
Argument:
None.
Possible value:
None.
Example:
GS-2124L# restore default
Restoring ...
Restore Default Configuration Successfully
Press any key to reboot system.
Kapitel 5: Operation of CLI Management (englisch)
LANCOM GS-2124
159