Other Functions; Display Panel Features - Albrecht AE2990 AFS Bedienungsanleitung

OTHER FUNCTIONS

BEEP Tone and Roger Beep: To enable the beep tone and roger beep, press and hold the
"SCN/ M/SCN" button for 3 sec. The display show up the
button once again to activate the roger beep, the beep icon will change to Roger Beep icon
, then use the UP/DOWN button to turn ON and OFF of beep and Roger beep sound.
Display Lamp: Provides lighting of entire digital liquid crystal for use in the dark or night time
application. The display lamp will automatically on as you turn on the unit and it automatically
off with in 8 sec. To turn on back the display lamp just presses the "FUNC" button for 2 sec.
and again it just stays "on" for 8 sec. and if you want to turn it off just repeat the same
procedure.

Display Panel Features

Illustrated below are all the VISUAL INDICATORS that appear on the display, and the
corresponding feature function that they associate with:
Liquid Crystal Display Panel: The state of the art liquid crystal panel provides the user with
a visual information center on the operation and status of the unit.
CAUTION: Due to the components inherent in them, liquid crystal displays should not be
subjected to extremes of temperature or humidity. If the unit is exposed to temperatures
below –20° C (-5° F) or above +60 °C (+140° F), the d isplay may temporarily cease to function
properly, and in some cases, could result in permanent damage. Do not subject radio to
extreme conditions, such as a closed automobile in direct sunlight or continuous sub-zero
temperatures.
All liquid crystal displays have a preferred viewing angle when the display contrast is at a
maximum. The best viewing point will vary by user, depending on such variables as
temperature, humidity, battery condition, and the actual users' eyesight.
A. TX:
B. Function
C. Low:
A A
B B C C
LOW SCAN RF-G MIC-G PS
V
U
FM FM
T
AM AM
S USB USB
R
LSB LSB
Q
RPT SQ RPT SQ
P
O N
Indicates that radio is in the "transmit" mode.
Indicated the "FUNC" button has been selected, which allows for
operation of many of the "transmit" mode.
Indicates that user has selected the Low power output mode. When the
indicator is not shown, radio is in full output mode.
D D E E F F G G
1 1 5 5 9 9
M L
25
icon, press SCN/ M/SCN
H H
I I
J J
K K