ECS DURATHON2 Bedienungsanleitung Seite 15

12
Downloaded from www.Manualslib.com
Step 5. Connecting Cables and Power Connectors:
a. Connect the SATA hard drive to its
SATA cable
c. Connect 24-pin power cable
Please note that when installing 24-pin
power cable, the latches of power cable
and the ATX connector match perfectly.
Step 6: Connecting ports on the case:
Once the steps above have been completed, please connect the peripherals such
as the keyboard, mouse, monitor, etc. Then, connect the power and turn on the
system. Please install all the required software.
Using BIOS
The BIOS (Basic Input and Output System) Setup Utility displays the system's
configuration status and provides you options to set system parameters. When
you power on the system, BIOS enters the Power-On Self Test (POST) routines,
please press <DEL> or F2 to enter
POST screen may show a "CMOS Settings Wrong" message. Please
choose "Load Default Settings"
system hardware such as different CPU, memories, etc. may also trigger this
message.)
The sequence of installation may differ depending on the type of case and
devices used.
manuals search engine
b. Connect SATA power connector to the
SATA device
d. Connect 4-pin power cable
The ATX_12V 4-Pin power connector is used
to provide power to the CPU. When installing
4-pin power cable, the latch of power cable
matches the ATX_12V connector perfectly.
setup. When powering on for the first time, the
to reset the default CMOS values. (Changes to
enter BIOS and