Sleep Mode - Emerio DH-124928.1 Bedienungsanleitung

SLEEP MODE:

Press the sleep button to enter into the sleep mode; press the button again to exit the sleep mode.
-
Under this mode, all indicators will be off except sleep indicator light and water tank full indicator light.
-
Notice:
1. This appliance is equipped with memory function in case of power-down, except timer function.
2. Important:
Fault code "E2": Temperature / humidity sensor damaged; contact a professional for inspection and
maintenance.
Fault code "E3": Coil sensor damaged; contact a professional for inspection and maintenance.
DRAIN THE COLLECTED WATER
When the water tank is full, the water tank full indicator light will illuminate. The operation will stop
automatically and the buzzer will beep 20 times to alert the user that the water needs to be emptied from the
water tank.
Empty the water tank
1. Pull out the water tank from the appliance.
2. Discard the collected water.
3. Install the water tank back.
NOTE:
1. If you want to remove the water tank cover (B), you should detach the handle (A) first: detach the joinpoint
(a) of the handle (A) away from the slot (b). Pay attention to the direction of the slot (b).
2. When placing the water tank back, press the tank firmly into the place with both hands.
3. Do not remove the float from the water tank. The water full sensor will no longer be able to detect the water
level correctly without the float and water may leak from the water tank.
Continuous water drainage
The appliance has a continuous drainage plughole. Firstly, gently knock the lid (A) off with a hammer (B), then
connect the pipe (C); the condensed water can be continuously drained out. Install drain piping at a downhill
grade to make sure that condensed water can be drained continuously. Now the condensed water will be drained
out by this drainage plughole instead collected into the water tank.
- 9 -