Cleaning And Maintenance - Concept Rk 2110 Bedienungsanleitung

CAUTION
Prior to first use, we recommend boiling the maximum volume of water in the kettle at least 3 times, then
pouring it out. The kettle is then ready for operation.
The kettle may only be used with the supplied base.
OPERATING INSTRUCTIONS
1. Remove the kettle from the base (7), press the button for opening
the lid (4), open the lid (1), and fill the appliance with cold water
within the permitted maximum only. If the water level in the
kettle is under the recommended minimum, the kettle will keep
overheating and turning off prematurely.
Note: Make sure that the lid (1) is closed properly, otherwise the
kettle can not turn off automatically
2. Place the kettle on the base (7); electric contacts will get con-
nected automatically. Thanks to the central connector design, the
kettle can turn around 360° and be put on the base from any
side.
3. Connect the base to the mains.
4. Turn the kettle on by pressing the switch (6).
A control light on the switch (6) signals the kettle is in operation.
The kettle lid (1) must be properly closed when water is being
heated.
WARNING!
Do not open the lid during heating or immediately after heating is completed. Hot steam could scald
you!
5. After the boiling point has been reached, the kettle will turn off automatically, and the operating light
will go out. Water heating can be terminated prematurely by moving the switch (6) to the off position.
6. Remove the kettle from the base (7) and use the hot water.
7. If you want to reheat the water you have just finished boiling, wait for approximately 30 seconds before
reactivating the switch (6).
8. The kettle filter captures all potential impurities while pouring water.
Note: It is not a sign of a defect when a small amount of water droplets appear on the kettle base (7). It is
a small amount of condensed steam, which deactivates the kettle thermostat.

CLEANING AND MAINTENANCE

WARNING!
Always disconnect the power supply cable from the mains outlet before cleaning the appliance.
Make sure the appliance has cooled down before handling it.
Only use a wet cloth for cleaning the surface; never use detergents or hard objects, as they may damage it.
Never clean the unit under running water; do not rinse it or submerge in water.
Limescale removal
Impurities from water build up during normal use. These sediments can be removed
RK 2110
EN
Fig. 1
25