Technical Data; Functional Description - Pfaff Silverline HRH S Betriebsanleitung

Service Jack SILVERLINE HRH S
English
When raising vehicles:
The jack must not be used to transport loads.
The device should be located under the jacking points provided for the purpose by
the vehicle manufacturer and not under the vehicle directly.
The jack must be selected such that it can safely lift the load acting on the jacking
point of the vehicle.
Look up for the load in the vehicle owner's handbook or calculate it using the load
details in the vehicle's documents.
Do not stand on the jack or remain within the danger area while operate the jack.
A Do not stand under a raised load unless it is additionally supported.
Use additional supports (e.g. axle stands) if access to the underside of the
raised vehicle is required
Never leave a raised load unattended without additional support.
Do not touch any moving part of the jack.
All faults must be repaired immediately by a qualified service technician.
The jack should be positioned in such a way that it is only ever subjected to
downward pressure.
It must not be subjected to lateral pressure.
Before using the jack, ensure that it is standing on a firm surface of adequate load-
bearing capacity.
Raise loads, vehicles, etc. on one side only.
Do not use the jack in conjunction with other lifting gear.
The jack must only be loaded with downward-bearing weights.
The minimum distance from walls, doors and fixed objects must be at least 0.5 m.
Chock the raised vehicle to ensure that it cannot roll away, slip or otherwise fall off the jack.
Do not exceed the maximum load capacity indicated on the identification plate or listed in the
technical specifications.
Have the jack checked by a qualified service technician before it is used for the first time.
Daily examinations
Visual and function examination of the security parts: head, non-return valve, pressure control valve, drain valve.
Have the jack serviced by a qualified technician at least once a year.
Observe the inspection and servicing schedule.
Note that safe functioning cannot be guaranteed unless original accessories and spares are
used.

Technical data

Type
Ref.-no.:
Lifting capacity
Lift
Quick lift
min. height
max. height
Lift per pump stroke

Functional description

The term "service jack" refers to a manually operated, transportable hydraulic lifting device.
The load is supported by a rotary load supporting plate.
The load is lifted by a swiveling load arm which is mounted in the base frame on an articulated joint.
The lifting process is performed by a hydraulic pumping device involving a lifting piston, non-return valve,
overpressure valve and lowering device for the controlled release of the raised load.
The jack has four rollers to enable the user to transport it easily without a load.
technische Änderungen vorbehalten
.
HRH S 2,0 K HRH S 2,5 K HRH S 2,0 L HRH S 3,0 L HRH S 5,0 L
040008530
2
[t]
260
[mm]
no
h 125
[mm]
min
h 385
[mm]
max
8,12
[mm]
design changes under reserve
F 06.01.075
040008531 040008532
2,5 2
300 660
yes yes
140 140
440 800
5,9 14,6
changements techniques sous réserve
040008533 040008534
3 5
480 415
yes yes
125 145
605 560
17,7 12,2
Seite / page 9