Use For Intended Purpose; Safety Precautions - Pfaff Silverline HRH S Betriebsanleitung

Service Jack SILVERLINE HRH S
English
Read these instructions thoroughly before using the jack for the first time.
Observe all safety precautions.
Keep this document in a safe place.
Tip!
Warning!
Important note! Important information
Important note!

Use for intended purpose

This hydraulic service jack is a portable, manually operated device designed for the lifting and lowering of
partial loads (e.g. for raising one side of a vehicle to allow a wheel to be changed).
It is designed for manual operation only.
This device is not designed for permanent operation or for use in explosion-hazard areas.
Modifications may not be carried out on this jack without our express written permission.
Please observe the technical specifications and description of functions.
Accident prevention precautions
Ensure that all relevant local safety regulations are observed
This device conforms to the following German and international standards:
BGV D8 - Winching, lifting and towing devices
EC Directive 98/37 EC - Industrial machine directive
EN 982 Technical safety specifications for hydraulic devices
EN 1494 - Portable lifting devices
1)
Relevant current version

Safety precautions

This device must only be operated and serviced by suitable trained and qualified personnel.
(Definition of qualified staff as established in IEC 364)
Qualified persons are those whose education, experience, training, or knowledge of the relevant standards and
regulations, accident prevention legislation and operating conditions make them suitable to take responsibility for
the safe operation of the device – thereby recognising and avoiding any potential hazard.
The user is responsible for the safe operation of the jack.
The device is marked with its maximum lifting capacity.
The load to be raised must not exceed this maximum weight.
technische Änderungen vorbehalten
General, helpful tip
Contains a warning that a
general hazard exists. Risk of
injury if warming ignored
Assembly and adjustment
information
design changes under reserve
F 06.01.075
Important note!
Important note! Disposal of lubricants
Important note! Disposal
1)
changements techniques sous réserve
Maintenance
information
Seite / page 8