Operating Precautions; Placing Into Operation - Pfaff Silverline HRH S Betriebsanleitung

Service Jack SILVERLINE HRH S
English

Operating precautions:

Note:
Use the jack only on adequately compacted (stable) ground.
The jack must not be used to transport loads.
Ensure that the jacking handle has room to move freely.
Use additional supports for working under the raised load.

Placing into operation

design „L" 3t; 5t
Remove the transportation
safety device and lift up the
pump lever support
Operating instructions
Never use the service jack as transporting device.
Park the vehicle you wish to lift on flat, compacted ground.
Chock the raised vehicle to ensure that it cannot roll away, slip or otherwise fall off the
jack.
The device should be located under the jacking points provided for the purpose by the vehicle
manufacturer and not under the vehicle directly.
The load support plate must be positioned centrally under the jacking point.
Falls erforderlich rutschfeste, elastische Unterlage verwenden.
If necessary use a non-slip, elastic
Moving the jack into position
The jack can be pushed by the jacking handle under the load you want to lift and pulled out again after
use.
On the "L" version the jacking handle can be locked in various positions.
Design Quick lift „K" 2,5t
Adjust the basic height by inserting various thrust pieces.
Insert the jacking handle into the quick lift device and secure it.
Move the load arm under the jacking point with the drain valve
closed.
Position the load support plate by activating the quick lift
device.
Design Quick lift „L"
Operate foot pedal
technische Änderungen vorbehalten
design „L" 2t
Remove the transporta-
tion safety device
design changes under reserve
at design „L"
Insert the pump lever
and fasten it with screw
and nut
changements techniques sous réserve
F 06.01.075
only at design „L" 2t
Fasten the quick lift operating
lever with bolt and nut
secure
actuate
quick lift
Seite / page 10
locked