SUOMY SCRAMBLER Gebrauchsanleitungen Seite 32

EN
COMFORT PADDING
The internal padding can be easily removed for washing or replacing.
Internal padding
Removal
Insertion
ADJUSTMENT, DISASSEMBLY AND REASSEMBLY OF THE HELMET PEAK
Disassembly
Reassembly
Regulation
ANTI-RAIN SHELL
If provided, it is available as original Suomy spare parts, a special protective anti-rain shell to be fixed and fitted
over the helmet, as shown in pict. 11.
USE AND MAINTENANCE
The internal comfort padding is fixed to the helmet by Velcro.
Carefully lift the padding from the internal cap of the helmet and detach it from the Velcro (pic. 8A).
Lay the internal padding against the interior profile of the helmet. Exert a slight pressure
inside on the Velcro straps to ensure the correct fitting (pic. 8 B).
Make sure that it is properly positioned.
Loosen the fastening screws using hands (pic. 9 A and B).
Disengage the pin on the rotation fulcrum of the helmet peak C and remove the helmet peak.
Insert the pins in the appropriate screw hole provided in the internal shell (C and D),
insert and tighten the two screws A and B.
Slightly loosen the two screws A and B and rotate the helmet peak around the two
fulcrums C and D (pic. 10 A) until reaching the desired position (pic. 10 B).
Then tighten the screws A and B.