SUOMY SCRAMBLER Gebrauchsanleitungen Seite 31

EN
USE AND MAINTENANCE
STRAP ADJUSTMENT AND POSITIONING
After the helmet is properly worn, verify that the side of the strap is correctly positioned around the ears (pic. 4).
If this is not the case, lift the locking tab of the lateral adjustment system (pic. 5) and slide the strap inside until it
reaches the correct position. Make sure the strap does not partially overlap the ears and then re-tighten the
tab/flap of the adjusting system until it is completely locked.
BACK SIZE MICROMETRIC ADJUSTER
The back size adjuster is equipped with two regulation systems, one for the size and the other for the correct
height positioning.
Position the adjuster so that it lies on the occipital lobe. In case this does not occur use the height adjusters
located inside the helmet, and slide the adjuster upwards or downwards (pic. 6).
Then adjust the size using the adjustment wheel (pic. 7 A).
Turn the wheel clockwise to tighten or counter clockwise to decrease the tightening. Do this by using two fingers
as indicated in pic. 7 B.
WARNING: The adjustment of the system must ensure a good locking of the helmet on the head without
discomfort.