AEG SKE81811DC Benutzerinformation Seite 30

30 www.aeg.com
Problem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the "Coolmatic", or
after changing the tempera-
ture.
Water flows on the rear
plate of the refrigerator.
Water flows inside the refrig-
erator.
Water flows on the floor.
Possible cause
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The "Coolmatic function"
is switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Appliance is fully loaded
and it is set to the lowest
temperature
Temperature set in the ap-
pliance is too low and the
ambient temperature is
too high.
Temperature is set incor-
rectly.
This is normal, no error has
occurred.
During the automatic de-
frosting process, frost
melts on the rear plate.
Food products prevent the
water to flow into the wa-
ter collector.
The water outlet is clog-
ged.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
Solution
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "Coolmatic function".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Set a higher temperature. Re-
fer to "Operation".
Set a higher temperature. Re-
fer to "Operation"
Refer to "Operation" .
The compressor starts after a
period of time.
This is correct.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water out-
let to the evaporative tray.