Cleaning And Maintenance - Concept KK 1150 Bedienungsanleitung

OPERATING INSTRUCTIONS
Do not use it on wigs or animals.
1. Dry your hair with a towel after washing.
2. Brush your hair. Do not use hairspray or other flammable substances.
3. Connect the power cord plug to the wall outlet.
4. Turn the unit by the switch (2).Control lamp (3) blinks (default temperature
setting is 120°C). After the appliance reaches the set temperature, the control
lamp (3) will be lit continuously.
5. Set the required temperature using the -/+ (5) buttons for setting the
temperature (Fig. 1). While the unit is still reaching the set temperature, the
relevant control lamp (3) is blinking. After the set temperature is reached,
the relevant control lamp (3) is lit continuously. The operating temperature is
reached after approximately 90 seconds.
6. When putting down the unit during use, always switch it off.
7. Switch the unit off after use.
8. When using the unit in a bathroom, make sure you switch it off immediately
after use, and disconnect it from the wall outlet, as the proximity of water
and any contact of the unit with water are very dangerous, even if the unit is
switched off.
9. The hanging loop enables you to hang up the unit to store it.
Using the appliance for hair curling
1. Hold the appliance as shown in the Fig. For easier manipulation, you can also
use the other hand and hold the appliance at the cold ends of the tongs (8).
By pressing the lever (6) you open the curling tongs (7).
2. Grip the prepared hair strand in the curling tongs and curl the hair from the
tips into a curl (Fig. 4). The thinner the strand, the firmer the curl that may be
created.
3. After curling the hair into a curl, wait 10 to 15 seconds so that the hair shape
is fixed.
4. Unwind the curled hair strand (Fig. 5), by pressing the lever (6) open the
curling tongs (7) and take the formed hair strand out of the curling tongs (Fig.
6).
5. Use the same procedure repeatedly for other hair strands.

CLEANING AND MAINTENANCE

WARNING!
Before cleaning the unit, always disconnect the power cord from the wall outlet!
Prior to handling, make sure the unit has cooled down!
The surface of the unit may only be cleaned using a wet cloth. Do not use any
detergents or hard objects, as they may damage the unit's surface!
Never clean the unit under running water, do not rinse it, and do not
submerge it in water!
KK 1150
EN
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
25