Hose Drainage - Comedes BTR 50 Handbuch

Attention:
To ensure correct and safe operation of the unit, the float must not be removed from
•
the water tank
If the water tank is dirty, it should be cleaned. Use cold or warm water without
•
additives. Additives or cleaning utensils such as detergent, steel wool, benzene or other
chemical cleaners are not suitable as these can damage the tank and cause leakage.
To protect the compressor, it has a 3 minute switch-on delay.
•

Hose drainage

The Comedes BTR 50 can also be operated with a drainage hose (Ø11.0mm). To do this,
remove the water tank and attach a drainage hose.
Proceed as follows:
1. Remove the water tank and empty it completely.
2. Pull the plug from the hose connection of the water tank and insert it back into the
appliance.
3. Insert a suitable drainage hose from the outside through the opening provided in the
housing.
4. Now attach the hose to the hose connection of the water tank. If necessary, pull the
water tank slightly out of the device. Then close the tank cover.
5. Now lay the drainage hose to a suitable drain and make sure that the hose remains in
the intended position there.
6. To use the unit in tank operation again, pull off the drainage hose and close the
connection for the hose on the water tank securely and firmly with the plug.
EN-13
Make sure that the plug of the water tank closes the connection for
the hose securely and firmly.
Drainage hose
www.comedes.com