Assembly - Comedes BTR 50 Handbuch

Assembly

Figure 4:
Accessories included in delivery
1 Air dehumidifier
3 Stainless steel screw
5 Wheel
7 Screw nut
For the assembly is required:
• Wrench M6
• Screwdriver
• Soft underlay (blanket, sleeping mat, towel or similar)
Assembly steps for the BTR 50:
Please note that the device is heavy. To avoid injuries or damage to the device
and objects in the vicinity, the installation should be carried out by 2 persons.
Attention
A) Preparation
a. Remove the dehumidifier from the packaging and check it for damage
b. Check the accessories (mounting set) for completeness.
c. Prepare the tools required for the assembly.
B) Mounting (See Figure 4)
a. Carefully place the device on its front side. Lay a soft surface (blanket, mattress,
towel, etc.) underneath to avoid damage such as scratches.
b. Assemble the transport handle using the 4 stainless steel screws, as shown in Figure
4.
c. Mount the two wheels as shown in Figure 4.
d. Now carefully place the device on its back. Lay a soft surface (blanket, mattress,
towel, etc.) underneath to avoid damage such as scratches.
e. Mount the stand as shown in Figure 4.
f. Return the dehumidifier to an upright position.
EN-9
2 Transport handle
4 Spacer washer
6 Spacer washer
8 Pedestal
www.comedes.com