Coltech LS5T-UK Original Bedienungsanleitung Seite 4

15. Turn the power off.
Pull out the plug and push in the emergency stop button before servicing or changing any blades, drill bits,
cutters or sanding discs.
16. Remove all spanners and repair tools.
Make a habit of checking to make sure that the machine is free of all spanners and tools before turning
the power on.
17. Avoid accidental starts.
Do not walk around with your finger on the trigger of electric machinery if it is plugged in. Make sure that
the ON/OFF switch is set to OFF before plugging in any electric machinery.
18. Use the correct extension leads.
If you use extension leads outdoors, only use those designed for outdoor use.
Only use extension leads with adequate wire core area and roll out the whole lead.
19. Use common sense and be careful.
Think carefully before carrying out every action, so that it is carried out safely.
Never operate machines when you are tired, under the influence of medicine, etc.
20. Inspect the tool for damage.
Before starting the machine, make sure that the guards and other parts are undamaged and working
properly, that moving parts can rotate freely and are correctly aligned, that no moving parts can get caught
and that there is no fault or defect that could affect the performance of the machine. A safety guard or any
other part that is damaged should be repaired by a tradesman or replaced. Damaged power leads and
switches must always be replaced by a tradesman. Never operate the machine if you cannot stop or start
the tool safely.
21. Use only recommended accessories.
The use of non-recommended accessories can cause accidents and personal injury.
22. Should only be repaired by a qualified technician.
This machine conforms to current safety requirements. Repairs to the machine should only be carried out by
a tradesman using original spares; otherwise the machine could cause accidents and personal injury.
23. Electric machinery should be connected to the mains via a Residual Current Device. This can help
minimise the risk of an electric shock in the event of an earth fault or short circuit.
The machine must not be modified or used for any other purpose than that for which it has been designed.
Regularly check that all screws and nuts are tight.
1.2 Additional safety rules for log splitters
• Save the instruction manual, make sure that it accompanies the log splitter if it is borrowed.
• Read the warning labels on the log splitter and make sure that they are legible.
• Make sure that the electrical socket you intend to use has the correct voltage (230 V) before connecting
the log splitter.
• Never attempt to adjust the force setting yourself. The log splitter is pre-set at the factory for a maximum
splitting force of 5 tonnes. Tampering with the pressure settings can lead to diminished performance and
damage to the machine and result in serious person injury.
• Wear safety glasses, ear defenders and safety shoes if necessary.
• Always stand in such a way that you can perform all work tasks whilst maintaining good balance and grip
the control lever in one hand whilst pushing the power button with the other hand.
• Keep your hands and fingers well away from the pressure plate and always use common sense and care
while operating the machinery.
• Make sure that there are no bystanders or pets close to the machine, sharp splinters can be ejected with
great force.
• Switch off the log splitter and disconnect it from the mains supply whenever you take a break and before
starting any maintenance procedures. Make sure that the log splitter cannot be started by any children or
unauthorised person.
• The log splitter should be connected to the mains via an RCD for extra safety.
• Never use the log splitter in the rain or wet conditions.
• Never use the log splitter if the power switch, plug, mains lead or any other part is damaged. The defective
part must be replaced by a qualified repair person.
4