Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
CAUTION
Prior to first use, we recommend boiling the maximum volume of water in the kettle at least 3 times, then pouring it
out. The kettle is then ready for operation.
The kettle may only be used with the supplied base.
OPERATING INSTRUCTIONS
1. Remove the kettle from the base (6), open the lid (1), and fill the appliance with
cold water within the permitted maximum only. If the water level in the kettle is
under the recommended minimum, the kettle will keep overheating and turning off
prematurely.
Note: Make sure that the lid (1) is closed properly, otherwise the kettle can not turn
off automatically
2. Place the kettle on the base (6); electric contacts will get connected automatically.
Thanks to the central connector design, the kettle can turn around 360° and be put
on the base from any side.
3. Connect the base to the mains.
4. Turn the kettle on by pressing the switch (5).
A control light on the switch (5) signals the kettle is in operation. The kettle lid (1)
must be properly closed when water is being heated.
WARNING!
Do not open the lid during heating or immediately after heating is completed.
Hot steam could scald you!
5. After the boiling point has been reached, the kettle will turn off automatically, and
the operating light will go out. Water heating can be terminated prematurely
by moving the switch (5) to the off position.
6. Remove the kettle from the base (6) and use the hot water.
7. If you want to reheat the water you have just finished boiling, wait for approximately
30 seconds before reactivating the switch (5).
8. The kettle filter captures all potential impurities while pouring water.
Note: It is not a sign of a defect when a small amount of water droplets appear on the
kettle base (6). It is a small amount of condensed steam, which deactivates the kettle
thermostat.
CLEANING AND MAINTENANCE
Warning!
Always disconnect the power supply cable from the mains outlet before cleaning the
appliance.
Make sure the appliance has cooled down before handling it.
Only use a wet cloth for cleaning the surface; never use detergents or hard objects, as
they may damage it.
Never clean the unit under running water; do not rinse it or submerge in water.
Limescale removal
Impurities from water build up during normal use. These sediments can be removed
RK4020
RK4900
EN
Obr. 1
Fig. 1
23
19
Werbung
Inhaltsverzeichnis
